to move an instruction
up one position in the list of instructionsThis page requests you to add instructions for the set. The same set of instructions is available here as in the Package wizard. For details, refer to Instructions.
Note: For complete information about the features of packages supported by agents, refer to Package Features Supported by Axeda Agents.
1. Select an instruction from the list.
2. When prompted, type or select appropriate values for the parameters related to the instruction. If the instruction selected presents a new page (for example Upload instruction), the page is labeled 2.1, and clicking Next from it brings you back to this page. For details on the instructions you can add, refer to Instructions.
3. Click Add to add the instruction. When you have added all the instructions to the set, click Next.
Note: To change the parameters of an instruction that you have added, you must first select the check box for the instruction in the list, and then click Remove Checked. Then, you must add the instruction again.
1. In the table of defined instructions, do the following:
§ Click
the to move an instruction
up one position in the list of instructions
§ Click
the 
to move an instruction
down one position in the list of instructions
2. Repeat step 1 until the list of instructions is in the correct order, where the package will execute the instructions in order, starting at the top of the list.
3. When you have finished changing the order of the instructions, click Next.